Surface Active Restoration Agent

WAY2GO is a unique water soluble timber restoration product used to remove stains that SARA-CLEAN cannot remove.
WAY2GO removes:
· Water marks and stains
· Sap and resin stains
· Deep fungal stains
· Green stain from CCA treated (tanalised) timber
· Oil, grease, carbon stains and many other chemical stains

WAY2GO can restore, enhance and maximise the surface character of any species of timber.

Results can be quite spectacular. The dead fibres and stains are removed, leaving the good wood intact. Old grey or stained timber is restored back to its natural timber colour.
CD50® Liquid Art can then be applied to maintain and protect the renewed appearance.

Typical Applications
For use on decks, logs, house cladding, shingle roofs, window frames, outdoor furniture, decorative timber etc
WAY2GO has been used to "bring back to life" ancient wooden artefacts and historic pieces.

The surface to be treated must be free of paint film or similar resinous sealers. The surface is saturated with water and WAY2GO is applied liberally to the wet timber surface.

The active time will vary. Water stains and sap stains are usually removed within 30 minutes. Timber with deep stains or surface defects, or timber previously treated with CD50® may require up to 4 to 8 hours. WAY2GO may be left overnight, or even for several days before washing off, if stains are severe.

On Plywood, do not leave longer than two hours.

The WAY2GO is then washed off. Where possible a strong water wash up to 80 bar (1000 psi) is used, taking care not to shred surface tissue or scour sapwood.
NB: Pressures over 600 psi should not be used on soft timbers as this will scour out the sap wood.

Where strong water washing is not practical, it can be washed off with clean water and a brush. All traces of WAY2GO must be removed. For full instructions on how to use WAY2GO, see the Technical Data Sheet

Before and After using WAY2GO

Before and After using WAY2GO

Before

After

Before

After